Overview.This card lets you control your spindle with step and direction signals, as if it was an axis motor. It converts the step signal into and an analog (0-10VDC). This card also has a couple of relays that can be used to control the direction (CW/CCW) and enable the drive (On/Off).
A Variable Frequency Drive or Inverter works by modifying the frequency for AC motors. You can control most of these devices with an external analog signal (0-10VDC). That is, if there is 5VDC coming into through the control signal, the motor will run at 50% of full speed, if there was 10VDC, the motor will run at 100% of full speed. If there is no signal coming out, then the motor will stop.
This unit can also be used on many DC motor controllers by replacing the potentiometer that controls the speed.
Features.• Inputs a frequency (step) and outputs an analog 0-10VDC.• Has two relays that can be used to control the direction and enable and disable the drive.• Optoisolated output signals. The analog and CW and CWW signals are optically isolated, so this board can be used with drives that make grounds common with the mains that drive the VFD or motor. • Comes with an RJ45 Connector fast installation. With this connector you just have to plug in an standard RJ45 cable and will not require further wiring. For more info go to: http://cnc4pc.com/RJ45.htm.
Sample XML File
John Dobbs Tutorial
Wiring KBIC Speed Controller
Wiring Huanyang VFD
Wiring Minarik MM Series Speed Controller
Wiring the Speed Controller that comes with Sieg X3
Wiring Hitachi L100 VFD
FC250J (Wiring Diagram) / FC250J (Instructions)
Modifications to HAL on EMC2
Analog Output Using a KBIC Speed Controller
Sample wiring of a C6 to a WF250Y Inverter