Overview.
This unit is an
easy to use speed PWM-based controller for routers. It works by modifying the output
frequency according to an external control signal. This unit can be used with 110 or 220
VAC. It comes with 2 solid state
relay controlled plugs. The first
one has speed control and enable, the second one only enable. The first one could be used for spindle
speed control and the second one for starting and stopping a coolant pump or
vacuum.
Features.
-
Easy to install and configure
-
Built-in PWM-Based Speed Control.
(200Hz).
-
RJ45 connectors for all Inputs. You only have to use
standard networks cable to make all connections.
-
Microcontroller Based System. The
microcontroller based system allows the implementation of complex algorithms
for monitoring the system. It also allows the possibility of having firmware
upgrades without having to change the board and rewire your system.
-
Works with 110 or 220VAC at 60 or 50 HZ.
-
For 2.5HP or 1800 Watt Routers.
-
All TTL +5VDC or +3.3VDC Signals. Interface directly
with parallel port interface products and other cnc4pc.com cards. 5VDC (TTL)
signals are very common among automation devices.
-
Screw-On connections for all terminals. You only have
to screw-on the wires to make all your connections.
-
Comes with an RJ45
Connector fast installation. With this connector you just have to
plug in an standard RJ45 cable and will not require further wiring. For more
info go to: http://cnc4pc.com/RJ45.htm.
Specifications
|
INPUT
SPECIFICATIONS |
|
On-state
voltage
range |
2 to 5V
DC |
|
Minimum on-state input
current |
8 mA |
|
Maximum off-state
voltage |
0.8V |
|
PWM
Frequency |
200Hz |
|
Signal
Type |
Active
High |
|
ON-BOARD TRIAC
SPECIFICACTIONS |
|
Maximum Nominal Current (AC) |
15A RMS |
|
Maximum
Peak Current (AC) |
150A |
|
OUTPUT POWER
SPECIFICACTIONS |
|
Maximum Motor Power |
2.5 HP /
1800W |
PDF Manual
$76.00
