Monthly Archives: December 2020
Wiring of the C25XP board connection with PNP sensor

Wiring of the C25XP board connection with PNP sensors

Read more » Wiring of the C25XP board connection with NPN sensor

Wiring of the C25XP board with NPN sensors serial connection

Read more » Wiring of the C25XP board connection with Switch Mechanical Limit

Wiring of the C25XP board connection with Switch Mechanical Limits

Read more » Wiring sample of the C25XP Rev3 board connection with Huanyang VFD

Read more » STEP 1: Connect an E-Stop button to short the E-Stop terminals.
- This should give you a green LED.
- IF not, check other possible fault conditions and make sure they are not active.

STEP 2: Make sure the controller is connected to an Ethernet port on the PC and powered with LEDs ON.
- Connect only the C25XP.
- Set the jumpers for all axis as Active Axis off, so the board does not check for a cable disconnect.

Read more » STEP 1: Connect an E-Stop button to short the E-Stop terminals.
- This should give you a green LED.
- IF not, check other possible fault conditions and make sure they are not active.

STEP 2: Make sure the controller is connected to an Ethernet port on the PC and powered with LEDs ON.
- Connect only the C25XP.
- Set the jumpers for all axis as Active Axis off, so the board does not check for a cable disconnect.

STEP 3: Download the software
Read more » Initial Step by Step Wiring and Testing of a C94 with UCCNC
Read more » STEP 1: Connect an E-Stop button to short the E-Stop terminals.
- This should give you a green LED while the board is powered and e-stop is closed.
- IF not, check other possible fault conditions and make sure they are not active.

STEP 2: Make sure the controller is connected to an Ethernet port on the PC and powered with LEDs ON.

- Run the to establish the connection,
- Set a fixed IP on the PC’s LAN cad and whitelist t
Read more » Wiring PNP Switches to a C94 - Multifunction Board
Read more » Wiring information for NPN Switches on C94 - Multifunction Board
Read more »