UCCNC Plugin Configuration for THC on 
C76 or C94
UCCNC V1.2115

Software: UCCNC V 1.2115
http://www.cncdrive.com/UCCNC/setup_1.2115.exe

Hardware: C76 or C94 UC300ETH

 

Before starting the configuration and file installation, we recommend creating a backup of the current installation by right-clicking in the current installation folder and zipping it. 

right-click-2-zip

 

STEP 1: These wiring samples for connection can be used:
https://www.cnc4pc.com/blog/post/connection-c94-with-thc-1-and-pts-1

 

Step 2. Configure Torch Relay:

 

Step 3. Configure the THC pins:

Step 4. Test the Wiring and Configuration:

  • Press the knob three times to enter test mode in the THC and observe the ARC OK signal activate.
  • Turn the knob up or down to move the axis and observe the Torch UP and Torch Down LEDs activate when moving in each direction.  The Z-Axis should also move to adjust the position.
  • To exit test mode, press the knob once.

 

This instruction has been updated for these instructions.

Touch Sensor and Plasma Torch Height Control Configuration for UCCNC