CNC4PC
C47 - A/C SPEED CONTROLLER & RELAY BOARD
OVERVIEW
This unit is an easy to use speed PWM-based controller for routers. It works by modifying the output frequency according to an external control signal. This unit can be used with 110 or 220 VAC. It comes with 2 solid state relay controlled plugs. The first one has speed control and enable, the second one only enable. The first one could be used for spindle speed control and the second one for starting and stopping a coolant pump or vacuum.
FEATURES
Easy to install and configure
Built-in PWM-Based Speed Control. (200Hz).
RJ45 connectors for all Inputs. You only have to use standard networks cable to make all connections.
Microcontroller Based System. The microcontroller based system allows the implementation of complex algorithms for monitoring the system. It also allows the possibility of having firmware upgrades without having to change the board and rewire your system.
Works with 110 or 220VAC at 60 or 50 HZ.
>For 2.5HP or 1800 Watt Routers.
All TTL +5VDC or +3.3VDC Signals. Interface directly with parallel port interface products and other cnc4pc.com cards. 5VDC (TTL) signals are very common among automation devices.
Screw-On connections for all terminals. You only have to screw-on the wires to make all your connections.
Comes with an RJ45 Connector fast installation. With this connector you just have to plug in an standard RJ45 cable and will not require further wiring. For more info go to: http://cnc4pc.com/RJ45.htm
INPUT SPECIFICATIONS |
|
On-statevoltagerange |
2 to 5V DC |
Minimum on-state input current |
8 mA |
Maximum off-statevoltage |
0.8V |
PWM Frequency |
200Hz |
SignalType |
Active High |
ON-BOARD TRIAC SPECIFICACTIONS |
|
Maximum Nominal Current (AC) |
15A RMS |
MaximumPeak Current (AC) |
150A |
OUTPUT POWER SPECIFICACTIONS |
|
Maximum Motor Power |
2.5 HP / 1800W |