C62 - Dual Port Multifunction Board
CNC4PC
C62 - Dual Port Multifunction Board
FEATURES
-
Connects directly to the motion controller or Parallel Ports.
-
IEEE 1284 Standard compatible.
-
Built-in PWM-Based Speed Control.
-
Two Built-in Electromechanical Relays with NO and NC positions for spindle control.
-
RJ45 Connector for Easy VFD Connection.
-
Monitors E-Stop, Safety Charge Pump and fault signal from drivers.
-
Monitors VFD alarm signal.
-
Can enable and disable the drives.
-
Electromechanical Relay with NO and NC positions for general purpose (Port_2 16 or 17, jumper-selectable).
-
Microcontroller based SCHP.
-
RJ45 connectors for the axis.
-
Opt -isolated inputs.
-
Power terminal (12VDC / 24VDC).
-
Outputs can be 500mA open collector or +5vdc at 24mA TTL.
-
Status LEDs on all inputs and output connections.
-
Works directly with popular CNC hardware and software.
-
18 inputs and 16 outputs on 2 ports.
| SKU | C62 |
|---|---|
| Manufacturer | CNC4PC |
Frequently Asked Questions and Answers
- What is a Safety Charge Pump (SCHP)?
It is a watchdog. It is a feature in which the control software will send a pulse stream through a pin, as if it was moving an axis. Then a microcontroller on the breakout board will see that pulse stream and will know that the signals coming f...
Read more - I cannot get the green LED to enable on the breakout board
3 conditions must be met to get the enable LED:
- The board must be properly powered. Check the documentation on the board, as misundertand on how it is powered is very possible.
- The board must be connected to a PC/Mot...
Read more
- US and International modes of operations for VFDs (Variable Frequency Drives) and Speed Controllers
VFDs and motors have two way of operation, in the US we use CW and CCW, in the rest of the world, or INT (International) it is used START/STOP and DIRECTION. These settings can usually be adjusted VFD settings. The chances are that if you purchased th...
Read more
