can this board support torch height control ? i seen that ESS and MACH4 supports it, i would like to use that function.

10 views  January 20, 2021

Note this is a basic breakout board and you can assign the pins freely, so you can.  But I would suggest using a breakout board that supports +24vdc logic, Like the C25XP or C79.  +24vdc logic works better in noisy environments. 


Did you find it helpful?
   Ask a question

Terms & Conditions

There is no content for Term & Conditions.
I Agree with the Terms
© 2017 CNC4PC. All Rights Reserved.