I am getting an E-1 Error on a Plasmasensout THC sensor

167 views  June 27, 2019

This is error is due to noise entering the logic of the system.  The way of fixing it making sure things are properly grounded and making sure the negatives of the logic in the breakout board are not common with the main grounds or the negative or the main power supply.  If you need help troubleshooting this, please open a support ticket in our website and we will give you a hand with this:

https://www.cnc4pc.com/contact/


Did you find it helpful?
   Ask a question

Terms & Conditions

There is no content for Term & Conditions.
I Agree with the Terms
© 2017 CNC4PC. All Rights Reserved.