I am look at your touch probe, will this work on a c11G board if yes please send information. Thanks

279 views  November 8, 2020

Yes, the probes can very easily be wired to the C11G.  The probes ship with a female jack connector that can be connected to the terminals of the C11G.  the C11G has a jumper to set the input to be set to pulled-up.  If you have any issues wiring it, you can always open a support ticket on our website and we will give you a hand with this.

https://www.cnc4pc.com/contact


Did you find it helpful?
   Ask a question

Terms & Conditions

There is no content for Term & Conditions.
I Agree with the Terms
© 2017 CNC4PC. All Rights Reserved.