JavaScript seems to be disabled in your browser. For the best experience on our site, be sure to turn on Javascript in your browser.

Toggle Nav

Search

Send Quote

Name

Telephone

Comment

Do you want to ask quote for Shipping?

Country

State

City

Zipcode

Currency

Home
FAQ
What is the spindle configuration needed, in UCCNC, to control the spindle with the software? I am using a Huanyang GT series vfd.

Knowledge Base

Search our articles or browse by category below

887 views October 11, 2020

This would depend on the breakout board. The installers for our breakout boards would configure UCCNC to run the spindle with PWM at 300hz.

Did you find it helpful?