Knowledge Base
Search our articles or browse by category below
-
Can the M26 board get its 5v power from the 5v output on the c82 bob?
YES! This board uses less than 500mA. So, it can be powered with +5vdc from the C82 or pin 26 of the IDC26 for LPT3 of the ESS, or from a USB port.
Read more -
Is the ESS included with the C25XP?
Yes, you can choose to add it or not on checkout to give the option to users who already own an ESS to get the board without purchasing an ESS again. If you purchase it as a bundle, it will come with the ESS preinstalled.
Read more -
I have a Warp9 ESS. To reduce some EMI issues, I would like to convert ESS 5v pulse/direction to 24v since my motor drivers accept 5v or 24v pulse/direction signals. Is this the best board for that purpose?
Yes, the C79 or C80 would help you safely tap into +24vdc logic, which can be less prone to noise. Make sure the negative of the main power supply is not common with the negative of the ESS or breakout board. I think the C25XP should be a good option fo...
Read more -
Using 24v power, at what max amp should I used?
We recomend using a 2A ower supply. A larger power supply may be needed if powerinf other devices through the C25XP.
Read more -
C25xp can I use 5 volt on port 2 pin 2 to Com to close circuit install air pressure (do I need any resistance in a circuit )
That pin is an input pin. I understand the signal is active high, so +5vdc is high, so you would put GND or the common for the signal to COM2 and the signal itself to pin 2 port 2. The inputs are very easy to use, these are just bidirectional optos that...
Read more -
Hello,Does the C25XP card supply the smoothstepper card with 5vdc or is an external power supply required?
Yes, the C25XP has regulators to power the ESS. You really only need one power supply.
Read more -
Hello, is it necessary to connect the C22 board to the 5V terminal of the C25XP board or is it powered by Port 3? Thank you.
NO, the C25XP will power the C22 through the IDC26 to IDC26 ribbon cable.
Read more