Philip, You just need to configure the C34HS and C76 according to this wiring information: http://cnc4pc.com/Tech_Docs/DRIVER%20HS.pdf There is nothing to configure in the software, the fault will trigger a fault on the C76 that UCCNC will see as an e-stop.
Posted:
| |
Dear Arturo, I have bought your C76 board and i am very happy about it. Now i have a question about wiring a stepper motor. I have the IHSS60-36-30 from JMC. I have wired my board an the stepper motor without wiring the ENA and ALARM. Could you tell me how i have to wire this other pins. Do i have to setup the Alarm in UCCNC to or does it work from alone. I have one more question. Is it possible to buy the c34HS Interface and connect them with my IHSS60-36-30 and my C76? I hope you can help me. Best regards, Philipp
Posted:
| |