Rus, The TMC3in1 just plugs on the ESS and wiill work well with the C32. Here is the info you need to making it work with Mach4:
Posted:
| |
I high appreciate this post. It’s hard to find the good from the bad sometimes, but I think you’ve nailed it! would you mind updating your blog with more information?
Posted:
| |
I have purchased the TMC3in1 from you but will need advice on huck-up. I am running Mach 4,ESS,C32S BOB,EZ-Cam,Windows10x64. I believe the TMC3in1 has its own motion controller but I may need an additional BOB. Any advice you could give me would be greatly appreciated. My order is in the pending status because I would prefer to order the BOB at the same time as the TMC3in1. Thanks in advance Rusb7773
I started connecting my stepper drivers to the C32S BOB and am not sure about a ground wire. I would like to send a drawing I did to clarify my question. Thanks for your help and I am glad you survived the hurricane so well. Thanks Rus
Posted:
| |