C80 - Open Collector Breakout Board
From $36.00
To $56.50
CNC4PC
This card provides an easy way to connect your inputs and outputs from your port using a LPH26pin Ribbon Cable or parallel port. Provides terminals for connections and conditions signals for use in CNC applications.
OVERVIEW
This card provides an easy way to connect your inputs and outputs from your port using a LPH26pin Ribbon Cable or parallel port. Provides terminals for connections and conditions signals for use in CNC applications.
FEATURES
- Terminal Block for all I/Os.
- Expansion port for Mother Board. Connect the C76 or ESS expansion board.
- Open collector Outputs pins optoisolated 2, 3, 4, 5, 6, 7, 8, 9, 1, 14, 16, 17.
- Input pins 10, 11, 12, 13, 15.
- Terminal Block input with close by ground or +5VDC connections, COM and outputs with + 24VDC and ground
- Screw-On connections for all terminals. You only have to screw-on the wires to make all your connections.
- Status LEDs for enable.
- Fully Optoisolated Inputs and Outputs.
- External Enable Pin
- C79 Pins 2-9 = Inputs.
- C80 Pins 2-9 = Outputs.
| SKU | C80_B |
|---|---|
| Manufacturer | Doughy Drive |
Documents and Download
User ManualFrequently Asked Questions and Answers
- Using Open Collector Outputs and the output remains active when the output is deactivated.
The chances are that you need to add a 1N4007 diode to the coil. Note that we do not include this diode in the circuit, as many relays and other coils ship with this diode.
Read more - I bought the C82 control board with the ethernet smooth stepper. Can the C80 plug into the 3rd port of the ESS in this configuration?
YES! It will on LPT3 of the ESS.
Read more - I have a Warp9 ESS. To reduce some EMI issues, I would like to convert ESS 5v pulse/direction to 24v since my motor drivers accept 5v or 24v pulse/direction signals. Is this the best board for that purpose?
Yes, the C79 or C80 would help you safely tap into +24vdc logic, which can be less prone to noise. Make sure the negative of the main power supply is not common with the negative of the ESS or breakout board. I think the C25XP should be a good option fo...
Read more - I want to connect some 24v 2 wire pneumatic cylinder reed switched (the type with an LED) to the inputs. Can I connect them directly, or do I need to add a circuit with a pull up resistor to 24v in order to light the LED?
You can go directly with the C80.
Read more
