Touch and Tool Probe W 1/4 Shaft
CNC4PC
Overview
Touch and Tool Probe 1/4 shaft
This tool is both, an accurate 3 axis touch probe, or a tool height setting pad. It is easily converted from one use to the other in just a few seconds by simply swapping tips and adding or removing the screw-on arbor.
Can be used as Touch Probe or for Tool Height Setting.
Comes with 3.5mm male jack.
Wiring using the internal pull up resistor on the board.
Wiring using an exteral pull up resistor.
| SKU | TP2 |
|---|---|
| Manufacturer | CNC4PC |
Documents and Download
Wiring Information
-
Wiring sample to a Breakout Board Size: (65.5 KB) - Wiring Sample Acorn CNC with Touch and Tool Probe Size: (234.98 KB)
- Setup C94 with Probe TP1
-
Go to blog
External Document
- User manual Size: (1.43 MB)
Frequently Asked Questions and Answers
- I am look at your touch probe, will this work on a c11G board if yes please send information. Thanks
Yes, the probes can very easily be wired to the C11G. The probes ship with a female jack connector that can be connected to the terminals of the C11G. the C11G has a jumper to set the input to be set to pulled-up. If you have any issues ...
Read more - Does this come with the interchangeable probe plate? If not do your sell them?
Thanks for reaching out to us.We are currently shipping only with the female cable adapter. We are no longer shipping it with the disk, skirt, or replacement contactor as it is not really practical to exchange them. We should be offering soon a bundle ite...
Read more
