M16D POKEYS MOTION MOTHER BOARD
From $148.00
To $632.33
CNC4PC
POKEYS MOTION MOTHER BOARD
-
Designed for POKEYS ETH motion controller.
-
Built-in PWM-Based Speed Control and Two Built-in Electromechanical
-
Relays with NO and NC positions for spindle control.
-
The system monitors:
-
E-Stop
-
Safety Charge Pump.
-
VFD Fault.
-
Driver Fault.
-
Discrete Inputs and Outputs can be using with +5vdc TTL logic or 10-30vdc Logic.
-
Electromechanical Relay with NO and NC positions for general purpose (Port_2 16 or 17, jumper-selectable).
-
Microcontroller based SCHP.
-
Optoisolated inputs.
-
Can be powered with a voltage between +10 and +30VDC.
-
Status LEDs on all input and Output connections.
-
DIN Rail mountable.
-
Pluggable Screw-On Terminals.
-
It is compatible with family of C34 connector boards that allow quickly connecting to popular drives connecting not just the step and directionsignals, but also the fault and enable signals.
I/O SPECIFICATIONS
| OPTOISOLATED DIGITAL INPUT TTL SPECIFICATIONS | |
| On-state voltage range | 2 to 5VDC or 5 to 30vdc |
| Maximum off-state voltage | 0.8V |
| Typical signal delay | 2.8uS |
| DIGITAL OUTPUT TTL SPECIFICATIONS | |
| Maximum output voltage | 5VDC |
| Maximum output current | 50mA |
| Maximum off-state voltage | 0.44 V |
| Maximum supported frequency | 400KHz |
| Typical signal delay | 10nS |
| Time of transition to high impedance state | 12 s* |
| SKU | M16D_B |
|---|
Product Download
Wiring Information
-
Wiring M16D_R.1 + GECKO Size: (4.03 MB) - Wiring a Geckodriver to a M16D Size: (4.03 MB)
- Wiring for M16D with Huanyang VFD Alarma Size: (412.41 KB)
- Wiring for M16D without Huanyang VFD Alarma Size: (411.58 KB)
