C86 Connector Board for the MASSO-G3 Controller
OVERVIEW
This board interface is used to connect the MASSO-G3 CNC and C34 boards.
FEATURES
- RJ45 connectors for the axes.
- Enable and disable the drives.
- Servo Fault Detection.
- Electromechanical relay reflects the ACTIVE / FAULT Status of a servo.
- Power terminal (12VDC /24VDC).
- Status LEDs for fault axis and relay status.
- The board can be activated and start monitoring for a driver's fault using the axis enable or NO_FAULT signal. NEW
Documents
Related Products
Your Dynamic Snippet will be displayed here...
This message is displayed because youy did not provide both a filter and a template to use.