C25XP - Smooth Stepper Integrated Board

Full of Features

• Can ship with the Ethernet Smooth Stepper Motion Controller installed
• when purchased as a bundle.
• Built-in PWM-Based Speed Control and Two Built-in Electromechanical
• Relays with NO and NC positions for spindle control.
• The system monitors:
• - E-Stop
• - Safety Charge Pump.
• Electromechanical Relay with NO and NC positions for general purpose
• (Port_2 16 or 17, jumper-selectable).
• Microcontroller based SCHP (Safety Charge Pump).
• Optoisolated inputs working at 5-24VDC.
• Uses a single +24VDC to power the system. It generates the isolated voltage for the spindle control circuit and +5vdc for circuits using TTL logic.
•  Status LEDs on all input and output connections.
• DIN Rail mountable.
• Open Collector Outputs pins 1, 14, 16, 17 on Port 2.
• Screw-On connections for all terminals.
• Status LEDs for enable.
• The ENABLE Output of the C25XP is now tied to LPT3. So that relay or breakout boards connected to LPT3 will be enabled/disabled with the C25XP.
• Available installers and configuration files that configure all the functions of the board
• Driver Fault Detection pin.  NEW 
• 4 pins can be used for High-Speed input. NEW 

Connect ANYTHING with Clean and Simple Connections

• Steppers
• VFD
• Limits/Homes.
• Vacuum
• Probe
• Coolant Pump.
• etc...

Highly Expandable:

• Relay Boards. M26
• Breakout Boards. C79, C80, C10D
• Pendant. C22 / MPG2/MPG4/MPG16